Renkforce 1423362 Bedienungsanleitung Seite 49

Method 2:
• Both alarm functions can be switched on and off in sequence as well.
• For this, the projection alarm clock must be in regular mode. Push the button "CLOCK
SET" (B7) several times until the date is displayed (C11).
• Briefly push the button "ALARM SET" (B3) several times, until the desired alarm time
is switched on or off. When both alarms are off, the following sequence will apply for
every push of the button "ALARM SET" (B3):
alarm 1 on; alarm 2 on; alarm 1 and alarm 2 on; both alarms off;
The following applies to both methods:
• Above the seconds (C10), a small bell symbol will appear, indicating which of the
alarm times is on:
Alarm time 1 on
Alarm time 2 on
Alarm times 1 and 2 on
No symbol Alarm function off
Snooze function (snooze)
• When the alarm signal sounds, briefly push the button "SNOOZE / LIGHT" (B5) on
the rear of the projection radio alarm clock. The respective symbol in the display C10
flashes.
The 4-level alarm signal is interrupted for approx. 5 minutes and then restarted.
You can repeat this as often as you like.
• Terminate the snooze function prematurely by briefly pushing the button "ALARM
SET" (B3). The respective symbol in the display C10 will stop flashing.
Stopping the alarm signal
• When the alarm sounds at the set alarm time, it can be ended by briefly pushing the
button "ALARM SET" (B3).
• If no button is pushed, the alarm signal will be ended automatically after 2 minutes.
49