Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Stand-alone operation
In stand-alone mode, the LED CLW-100 flower effect can be used without controller as the device features a
built-in microphone, which provides automatic sound control.
Disconnect the EUROLITE LED CLW-100 flower effect from the controller.
Master/Slave operation
The master/slave operation enables that several devices can be synchronized and controlled by one master
device.
On the rear panel of the device you can find an XLR jack and an XLR plug, which can be used for
connecting several devices.
Choose the device which is to control the effects. This device then works as master device and controls all
other slave devices, which are to be connected to the master device via a DMX-cable. Connect the OUT jack
with the IN plug of the next device.
Set the DMX start address 001 on every slave-device.
OPERATION
After you connected the device to the mains, it starts running.
The LED display lights up and you can choose the desired mode via the buttons MODE, ENTER, UP and
DOWN.
The device has two operating modes. It can be operated in stand-alone or in DMX-controlled mode.
STAND-ALONE MODE
-
•
Automatic program mode
•
Sound Control Setting
•
Slave Setting
DMX-MODE
-
Stand-alone Mode
In the stand-alone mode, the device can be used without a controller.
Auto Mode Setting
Press the MODE button until the display shows AU.00. Press the ENTER button and select the desired
speed (00 - 99) via the UP or DOWN buttons. Press ENTER to confirm.
Sound Control Setting
Press the MODE button until the display shows SU.01. Press the ENTER button and select the desired
sensitivity (01 - 99) via the UP or DOWN buttons. Press ENTER to confirm.
Slave Setting
Set the DMX start address 001 on every slave-device.
22/27
00065878, Version 1.0
Werbung
Inhaltsverzeichnis
