Progress PVS 1540 Benutzerinformation Seite 22

22 progress
Using the detergent
A B
30
20
Setting and starting a programme
Setting mode
For some settings it is necessary that the
appliance is in setting mode.
The appliance is in setting mode when, af-
ter the activation, all the programme indica-
tors come on.
If the control panel does not show this con-
dition, press and hold, at the same time,
button and button
ance is in setting mode.
Starting a programme without delay
start
1. Open the water tap.
2. Press the on/off button to activate the
appliance. Make sure that the appliance
is in setting mode.
3. Press the button of the programme you
want to set. The related programme in-
dicator stays on while all the other pro-
gramme indicators go off.
4. Close the appliance door, the pro-
gramme starts.
Starting a programme with delay start
1. Set the programme.
2. Press the delay start button again and
again until the indicator of the number of
hours you want to set comes on. You
can set 3 or 6 hours.
• The delay start indicator comes on.
3. Close the appliance door, the count-
down starts.
• When the countdown is completed,
the programme starts.
A
-
+
C
until the appli-
1. Press the release button (B) to open
the lid (C).
2. Put the detergent in the compartment
(A) .
3. If the programme has a prewash
phase, put a small quantity of deter-
gent on the inner part of the appliance
door.
4. If you use detergent tablets, put the
tablet in the compartment (A).
5. Close the lid. Make sure that the re-
lease button locks into position.
Opening the door while the appliance
operates
If you open the door, the appliance stops.
When you close the door, the appliance
continues from the point of interruption.
Cancelling the delay start while the
countdown operates
When you cancel the delay start, also the
programme is cancelled.
1. Press and hold, at the same time, but-
ton and button
gramme indicators come on.
2. Set the programme again.
Cancelling the programme
1. Press and hold, at the same time, but-
ton and button
gramme indicators come on.
Make sure that there is detergent in the
detergent dispenser before you start a
new programme.
At the end of the programme
The indicator
1. Press the on/off button to deactivate the
appliance.
2. Close the water tap.
If you do not press the on/off button,
the AUTO OFF function automatically
deactivates the appliance a few mi-
nutes after the end of the programme.
This helps to decrease the energy con-
sumption,
until all the pro-
until all the pro-
comes on.