Set Flash Time; Change Pin - Renkforce 1312695 Bedienungsanleitung

u Set Flash Time
This setting is usually only needed for switchboards.
• Starting in the standby mode, briefly push left function button (1).
• Use the buttons „
(„BS Settings") and push the left function button (1) briefly for confirmation.
• Use the buttons „
function button (1) briefly for confirmation.
• Use the buttons „
short flash time, „Flash-2" = long flash time).
• Save the setting with the left function button (1); a brief confirmation sound is emitted.
u Change PIN
This function changes the PIN of the base station (basic setting „0000").
• Starting in the standby mode, briefly push left function button (1).
• Use the buttons „
(„BS Settings") and push the left function button (1) briefly for confirmation.
• Use the buttons „
function button (1) briefly for confirmation.
• Then enter the old PIN with the numeric buttons (in the delivery condition „0000"). Push the left function
button (1) briefly for confirmation.
• Now enter the new PIN with the numeric buttons (0000 to 9999 possible, always four digits). Push the left
function button (1) briefly for confirmation.
• For reasons of safety, enter the new PIN again. Push the left function button (1) again briefly for confir-
mation.
The new PIN is now saved.
Always write down the new PIN. Otherwise, you cannot log on or delete a mobile unit.
102
" (2) or „ " (12) to select the submenu for the setting of the basis station
" (2) or „ " (12) to select the submenu for setting the flash time and push the left
" (2) or „ " (12) to choose between two different flash time settings („Flash-1" =
" (2) or „ " (12) to select the submenu for the setting of the basis station
" (2) or „ " (12) to select the submenu for changing the PIN and push the left