I) Viewing/Deleting Saved Photographs; Setting Time And Date - Renkforce 1373174 Bedienungsanleitung

i) Viewing/Deleting Saved Photographs

• If you briefly push the "
the lower LED (11) lights up yellow.
• You can now use the " " (4) or." " (7) buttons to view the saved photographs. The
image number appears at the top of the display.
Up to 100 photographs at most can be saved (the maximum number of pictures
depends on the picture content and possible compression of the individual
images).
When the memory is full, the respective oldest photograph is always overwrit-
ten automatically when a visitor rings at the outdoor unit (or you take a picture
manually via the "
• To delete the displayed photograph, briefly push the button " " (6). A waste bin icon
flashes at the centre of the screen.
Press the " " button (5) to confirm deletion.
To cancel deletion mode, just wait for a few seconds until the flashing waste bin symbol
disappears.
• To leave the display mode again, just wait for a few segments until the regular camera
screen appears again.
Push the " " button (12) briefly then to turn off the display and switch the indoor unit
to standby mode.
j) Setting Time and Date
Every photograph that is saved by the indoor unit is automatically applied with
a display of date and time.
This way, you can check, for example, when a visitor has pushed the bell button
in your absence.
• If you briefly push the "
the lower LED (11) lights up yellow.
• Keep the " " button pushed for three seconds; then you can set the date and time.
Use the " " or " " buttons (6) to switch between the settings for year, month, date,
hours and minutes. The respective active setting item is highlighted in red.
Modify the respective value marked in red with the " " (4) and " " (7) buttons.
• Save your setting by briefly pushing the "
" button (12) at the indoor unit, the camera image appears;
" button (5)).
" button (12) at the indoor unit, the camera image appears;
" (5) button.
55