Removing The Glass-Ceramic Hob; Electrical Connections - Electrolux EHS 602 P Gebrauchsanweisung

Removing the glass-
ceramic hob
1. Disconnect the appliance from the electrical sup-
ply.
2. Push the hob upwands from underreath.
Contrary to the Regulations for House Installations of
the SEV, par. 47330.1, the built–in appliance may be
installed in flammable material. Parts, side panels,
reinforcement rails etc., which protrude into the space
below the cooking zones must be made of inflammable
materials.
Limitation of this space: width 550 mm, height 20 mm
from the underside of the hob, depth 60 mm from be-
hind for a worktop depth of 600 mm. Inflammable walls
and ceilings must be fitted with fire–resistant coatings
above the cooking surface, in accordance with the fire
brigade regulations for the respective area.

Electrical connections

Before connecting the appliance, check that the vol-
tage quoted on the rating plate – that is, the nominal
voltage of the appliance – corresponds to the available
mains voltage. The rating plate can be found on the lo-
wer housing of the glass–ceramic hob.
The mains connection of the ceramic hob must take
place using the provided connection cable in accor-
dance with the connection diagram (Fig. 3), and must
be carried out so that it is possible to disconnect all po-
les with a contact opening of at least 3 mm, e.g., using
an LS circuit breaker, earth–leakage circuit breaker, or
fuse.
If the mains connection cable has to be replaced,
a cable with Spare Parts No. 374 3700 00/1 must be
used.
Remove any protective films from the cooking surface.
After connecting the electrical supply, all coo-
king zones should be briefly switched on one
after the other at their maximum power, in or-
der to test whether they are operational.
braun =
schwarz =
blau =
grün/gelb =
brun =
noir =
bleu =
vert/jaune =
marón =
negro =
azul =
verde/amarillo =
48
brown
black
blue
green/yellow
brown
black
blue
green/yellow
brown
black
blue
green/yellow
Fig.3