Boost Facility; Selecting The Boost Facility - Electrolux EHS 602 P Gebrauchsanweisung

Boost facility

This facility provides an initial heat boost to the cooking
zone, before its resets to the lower power level selec-
ted. The length of the heat boost is dependent on the
power level selected as shown in the table below.
Selecting the boost
facility
1. Press the cooking zone control (2) of the required
cooking zone.
2. Using the increase control (5), select a power le-
vel between 1–8. You have 10 seconds in which
to select the correct power level.
After 5 seconds, «A» appears in the power level. The
boost facility has been activated.
The cooking zone will now heat up at power level 9,
and, after the defined time (see Table 1), will switch
down to the selected power level.
Example: You select power level 6. After 5
seconds, the boost function switches on.
With this setting, the cooking zone will
heat up for 2.5 minutes at power level 9,
and will then switch down to power
level 6.
The automatic heat–up function will not be
activated if you:
=> select a power level using the Minus key (4)
=> select power level 9
Table 1
Automatic Heat–up function
Power level
1
2
3
4
5
6
7
8
9
time in minutes
1
3
4,8
6,5
8,5
2,5
3,5
4,5
–––
2
37