Unpacking And Control; Installation Instructions; Installing Into A Kitchen Worksurface - Electrolux EHS 602 P Gebrauchsanweisung

Unpacking and control

Please examine the appliance for any damage sustai-
ned during transportation!
If the appliance is damaged contact your retailer be-
fore the appliance is connected.
Packing material should be disposed of properly.
Please keep packaging away from children, and dis-
pose of with due regard for the environment.

Installation Instructions

The appliance must only be installed by a qua-
lified electrician.
During installation, and when carrying out ser-
vice work, the appliance must be separated
from the electrical supply: Remove the fuse, or
switch off circuit breaker.
The general guidelines for the operation of
electrical appliances, the regulations of the re-
sponsible electricity–supply company, and the
information in the installation instructions must
be followed exactly.
Damaged hobs with cracks or breakages in the
STOP
glass–ceramic surface must not be connected
to the electrical supply.
Installing into a kit
chen worksurface
The electrical safety of the appliance must be
ensured by a correct installation.
Protection against accidental contact with
electrical elements, and the electrical safety
according to the SEV/VDE regulations must be
ensured by the correct installation of the ap-
pliance in standardised, matching, mounting
cabinet. This also applies to the metallic lower
casing of the appliance. The latter must not be
freely accessible, even for installations away
from the wall.
Installation cabinets must be installed and se-
cured so that they cannot tip over.
46