Offsound Control (Deactivation And Activation Of The Sounds); Power Management; Hints And Tips - Electrolux GK29TCIO Benutzerinformation

14 www.electrolux.com
deactivate the hob with
operates again.
5.11 OffSound Control
(Deactivation and activation of
the sounds)
Deactivate the hob. Touch
seconds. The display comes on and
goes out. Touch
comes on. Touch
zone to choose one of the following:
• - the sounds are off
• - the sounds are on
To confirm your selection wait until the
hob deactivates automatically.
When the function is set to
hear the sounds only when:
• you touch
• Minute Minder comes down
• Count Down Timer comes down
• you put something on the control
panel.

5.12 Power management

If multiple zones are active and the
consumed power exceeds the limitation

6. HINTS AND TIPS

WARNING!
Refer to Safety chapters.
6.1 Cookware
For induction cooking zones
a strong electro-magnetic
field creates the heat in the
cookware very quickly.
Use the induction cooking zones with
suitable cookware.
• The bottom of the cookware must be
as thick and flat as possible.
• Ensure pan bases are clean and dry
before placing on the hob surface.
• In order to avoid scratches, do not
slide or rub the pot across the ceramic
glass.
Cookware material
the function
for 3
for 3 seconds. or
of the front left
you can
of the power supply, this function divides
the available power between all cooking
zones. The hob controls heat settings to
protect the fuses of the house
installation.
• If the hob reaches the limit of
maximum available power (refer to
the rating plate), the power of the
cooking zones will be automatically
reduced.
• The heat setting of the cooking zone
selected last is always prioritised. The
remaining power will be divided
between the previously activated
cooking zones in reverse order of
selection.
• The heat setting display of the
reduced zones changes between the
initially selected heat setting and the
reduced heat setting.
• Wait until the display stops flashing or
reduce the heat setting of the cooking
zone selected last. The cooking zones
will continue operating with the
reduced heat setting. Change the
heat settings of the cooking zones
manually, if necessary.
• correct: cast iron, steel, enamelled
steel, stainless steel, multi-layer
bottom (with a correct marking from a
manufacturer).
• not correct: aluminium, copper,
brass, glass, ceramic, porcelain.
Cookware is suitable for an induction
hob if:
• water boils very quickly on a zone set
to the highest heat setting.
• a magnet pulls on to the bottom of the
cookware.
Cookware dimensions
• Induction cooking zones adapt to the
dimension of the bottom of the
cookware automatically.
• The cooking zone efficiency is related
to the diameter of the cookware. The
cookware with a diameter smaller
than the minimum receives only a part