Troubleshooting - ZANKER KDT10001FB Benutzerinformation

To prevent this, we recommend to run long duration
programmes at least 2 times per month.

Troubleshooting

The appliance does not start or it stops during opera-
tion.
Before you contact the Service, refer to the informa-
tion that follows for a solution to the problem.
Alarm code
• The end indicator flashes 1 time intermittently.
• Acoustic signal sounds 1 time intermittently.
• The end indicator flashes 2 times intermittently.
• Acoustic signal sounds 2 times intermittently.
• The end indicator flashes 3 times intermittently.
• Acoustic signal sounds 3 times intermittently.
Warning! Deactivate the appliance before you
do the checks.
Problem
You cannot activate the appliance.
The programme does not start.
The appliance does not fill with water.
The appliance does not drain the water.
The anti-flood device is on.
After the checks are completed, activate the appli-
ance. The programme continues from the point of in-
terruption.
If the problem occurs again, contact the Service.
If other alarm codes appear, contact the Service.
22
With some problems, the end indicator flashes in-
termittently to show an alarm code.
The appliance does not fill with water.
The appliance does not drain the water.
The anti-flood device is on.
Possible solution
Make sure that the mains plug is connected to the mains
socket.
Make sure that there is not a damaged fuse in the fuse box.
Make sure that the appliance door is closed.
Make sure that the water tap is open.
Make sure that the pressure of the water supply is not too low.
For this information, contact your local water authority.
Make sure that the water tap is not clogged.
Make sure that the filter in the inlet hose is not clogged.
Make sure that the inlet hose has no kinks or bends.
Make sure that the sink spigot is not clogged.
Make sure that the drain hose has no kinks or bends.
Close the water tap and contact the Service.
If the washing and drying results are not
satisfactory
Whitish streaks or bluish layers on glasses and
dishes
• The released quantity of rinse aid is too much. Ad-
just the rinse aid selector to a lower position.
Problem