After Treatment; Possible Reactions And Side-Effects; Light And Sound Signals During Use - Philips PR3092 Bedienungsanleitung

ENGLISH
22

After treatment

Treatment ends automatically after the treatment time in the selected
mode has elapsed, unless you remove the BlueTouch Pain Relief Patch and
press the mode button to stop treatment earlier.
Note: A sequence of two different tones indicates that the BlueTouch Pain
Relief Patch switches off and treatment has ended.
1 Loosen the strap and remove it from your back.
2 Remove the BlueTouch Pain Relief Patch from the strap.
3 Recharge the BlueTouch Pain Relief Patch if necessary
(see section 'Battery level signals').

Possible reactions and side-effects

- It is normal for the skin to become a little red during treatment.
This skin redness is caused by increased blood circulation due to
the warmth of the BlueTouch Pain Relief Patch. This skin redness is
harmless and fades after the treatment has ended.
- You may sometimes notice tanning after treatment. The cause of this
tan is the exposure to light - a similar effect to that caused by sunlight
- or to warmth. This effect is harmless and fades away by itself after a
number of weeks and sometimes a few months. Postpone treatment
until the tan has disappeared. To prevent tanning, resume treatment
in a lower mode and avoid excessive pressure on the BlueTouch Pain
Relief Patch during treatment, for example by sitting or lying on it or by
leaning heavily against it.

Light and sound signals during use

Overheating signal
1 If the sensor measures a too high temperature, the BlueTouch Pain
Relief Patch switches off for safety reasons.
2 If you try to restart the BlueTouch Pain Relief Patch within the
standard cooling-down time of 10 minutes after switching off,
the charging light flashes red three times.
3 After the standard cooling-down time of 10 minutes, the BlueTouch
Pain Relief Patch can be switched on again and the timer starts
counting down where it stopped.
Note: If treatment is not resumed within 2 hours, the timer is automatically reset.
Resetting signal
When the software of the BlueTouch Pain Relief Patch no longer responds
or another unexpected failure occurs, you can reset the BlueTouch Pain
Relief Patch.
1 Connect the BlueTouch Pain Relief Patch to the mains with the adapter.