Herunterladen Diese Seite drucken

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

English
introduction
Read this user manual carefully before you use the straps for the BlueTouch
Pain Relief Patch and save it for future reference.
intended use
The BlueTouch Pain Relief Patch is intended to be used on the upper or
lower back and can be positioned and adjusted on the treatment area by
means of a fabric strap.
important
-
Only use the BlueTouch Pain Relief Patch in one of the Philips straps
that has been specially designed for it. The straps are not supplied with
the patch and have to be obtained separately.
-
To prevent damage to the drum of the washing machine or to other
laundry in the drum, wash the straps in a fine-mesh washing bag.
Explanation of symbols
-
This symbol means: Wash at a temperature of 30°max (Fig. 1).
-
This symbol means: Do not bleach (Fig. 2).
-
This symbol means: Do not tumble-dry (Fig. 3).
-
This symbol means: Do not iron (Fig. 4).
-
This symbol means: Do not dry clean (Fig. 5).
-
This symbol means that the material has been tested for harmful sub-
stances according to Oeko-Tex
®
standard 100. (Fig. 6)
-
This symbol means that this strap is to be used on the lower back. (Fig. 7)
-
This symbol means that this strap is to be used on the upper back. (Fig. 8)
Using your BlueTouch straps
The preferred method for fastening the BlueTouch Pain Relief Patch to the
body is by means of one of the fabric straps. There is a special strap for
treatment of the upper back and a special strap for treatment of the
lower back.
4222_005_0333_2_DFU Leaflet_A6_v2.indd 1
Positioning the lower back strap
To place the BlueTouch Pain Relief Patch in the strap, follow the steps below.
1
Put the lower back strap and the BlueTouch Pain Relief Patch in front
of you on a table. Slide the left side of the BlueTouch Pain Relief Patch
behind the elastic edge of the opening in the strap. (Fig. 9)
Then slide the other end of the BlueTouch Pain Relief Patch behind
2
the opposite elastic edge of the opening so that the whole patch is in-
side the lower back strap. Check to make sure that the LEDs are not
covered by the material of the strap. If necessary, shift the BlueTouch
Pain Relief Patch a little (Fig. 10).
Remove clothing from the area to be treated.
3
Note: Make sure the skin in the area to be treated is clean, entirely dry and free
from creams, lotions and other cosmetics.
4
Wrap the lower back strap with the BlueTouch Pain Relief Patch in it
around your waist with the opening of the strap facing your back (Fig. 11).
5
Fasten it with the Velcro strips on both ends of the lower back
strap. (Fig. 12)
Note: Make sure the BlueTouch Pain Relief Patch in the strap is located on the
area to be treated and the LED area is in contact with the skin.
Positioning the upper back strap
To put the BlueTouch Pain Relief Patch in the upper back strap, follow
1
the same procedure as described in steps 1 and 2 in section 'Position-
ing the lower back strap' above.
Remove clothing from the area to be treated.
2
Note: Make sure the skin in the area to be treated is clean, entirely dry and free
from creams, lotions and other cosmetics.
Put the upper back strap on your back with the opening of the strap
3
facing your back (Fig. 13).
Note: Make sure the BlueTouch Pain Relief Patch in the strap is located on the
area to be treated and the LED area is in contact with the skin (Fig. 14).
Fasten the waistband with the Velcro fasteners and fasten the
4
shoulder straps to the two parts of waistband with the Velcro
fasteners (Fig. 15).
Note: You can also fasten the shoulder straps crosswise. This may provide a
better fit in some situations (Fig. 16).
Cleaning
Always remove the BlueTouch Pain Relief Patch from the strap before
you put the strap in the washing machine to clean it.
-
The fabric straps can be washed in the washing machine (Fig. 17).
Caution: To prevent damage to the drum of the washing machine or to
other laundry in the drum, wash the straps in a fine-mesh washing bag.
-
Use a gentle cycle and a temperature of 30°C maximum. Dry the straps
on the air and not in the tumble dryer. Do not iron the straps.
Replacement
You can purchase new straps under typenumbers:
-
PRP-LBS-6123: Lower back strap S/M
-
PRP-LBS-6126: Lower back strap L/XL
-
PRP-UBS-6113: Upper back strap S/M
-
PRP-UBS-6116: Upper back strap L/XL
Philips Lighting BV
0344
Light & Health Venture
Mathildelaan 1
0344
5616 BH Eindhoven
The Netherlands
4222.005.0333.2
Register your product and get support at
www.philips.com/welcome
PRP-LBS-6126
PRP-LBS-6123
PRP-UBS-6116
PRP-UBS-6113
1/10/12 12:05 PM

Werbung

loading

Inhaltszusammenfassung für Philips PRP-LBS-6126

  • Seite 1 Note: Make sure the skin in the area to be treated is clean, entirely dry and free Only use the BlueTouch Pain Relief Patch in one of the Philips straps that has been specially designed for it. The straps are not supplied with from creams, lotions and other cosmetics.
  • Seite 2 Rand der Öffnung, Hinweis: Sie können die Schultergurte auch über Kreuz befestigen. In einigen speziell von Philips entwickelten Rückenbänder. Die Rückenbänder sind Situationen kann dies eine günstigere Lösung sein (Abb. 16). dass sich das gesamte Patch im Rückenband für den unteren Rücken nicht im Lieferumfang enthalten und müssen separat erworben werden.

Diese Anleitung auch für:

Prp-lbs-6123Prp-ubs-6116Prp-ubs-6113