➏ Trouble Shooting; Symptoms And Confirmation - Elmo MX-1 Bedienungsanleitung

➏ TROUBLE SHOOTING

■SYMPTOMS AND CONFIRMATION

Check the following items. If any abnormality is found, consult the dealer from whom you
purchased this product or our nearest branch/office.
Symptom
No image is displayed.
No image is displayed.
The image is out of focus.
The image is too dark.
The image does not move.
The image is striped.
Possible cause/ remedy
・ The cable is not correctly connected.
・ Zoom is set at the TELE side, displaying only the white or
black part of the document.
・ If you turn the power ON immediately after turning it OFF,
the unit may not start. Wait for several seconds after
turning the power OFF, and then turn it back ON.
・ The USB cable is disconnected.
・ The switch in the side panel is set to the left. Make sure
that the switch is set to the right.
・ Image Mate 4 is not started correctly. Restart Image
Mate 4 and try to connect again.
・ The MX-1 is not selected in the setting of Image Mate 4.
・ The document (object) is too close to the lens. Move the
document (object) slightly away from the lens.
・ The intensity of the lighting is insufficient.
Press the button on the operating panel to adjust the
brightness. Or press the
lighting.
・ The "Freeze" function is selected by pressing
on the Operating panel. Cancel the freeze status by
pressing button again.
・ The "Freeze" function is selected by Image Mate 4.
Cancel the freeze status to resume the live image feed.
・ This may be interference fringes between dots of printed
matter and TV scanning lines or CMOS pixels. Changing
the shooting range may improve the problem.
・ The image may be distorted when shooting a monitor
screen while the live image feed is displayed.
43
button to turn on the LED
P.33
button
P.33
日
本
語