Installation Procedure; Post-Installation Check - Endress+Hauser RMA42 Handbuch

RMA42
4.4

Installation procedure

1.
1.
1. Push the upper top-hat rail clip upwards and the lower clip downwards until the clips
engage in position.
2. Position the device on the top-hat rail from the front.
3. Slide the two top-hat rail clips together until they engage in position.
To disassemble the device push the top-hat rail clips upwards or downwards (see 1.) and
remove the device from the top-hat rail. Also only one clip can be opened and the device can
be tilted accordingly to remove it from the top-hat rail.
4.5

Post-installation check

• Is the top-hat rail clip engaged?
• Is the device securely fixed to the top-hat rail?
• Are all the plug-in terminals securely locked in place?
• Are the temperature limits observed at the installation location →  32?
Endress+Hauser
3.
2.
3.
Installation
A0011766
33