Maintenance; Replacement Of Lamps - Stahl 6009/5..-....- Serie Betriebsanleitung

Maintenance and repair
EN

11.1 Maintenance

EN
EN
EN
EN
EN
• Consult the relevant national regulations to determine the type and extent of
EN
inspections.
EN
• Adapt inspection intervals to the operating conditions.
EN
The following tests and measures must be carried out during regular maintenance.
EN
Check
EN
the permissible ambient temperature
EN
EN
EN
the enclosure components for formation of
EN
cracks and damage.
EN
EN
its intended use
EN
EN
EN
if the conductors are clamped properly
EN
the cables for ageing and damage
EN
EN
the seals for ageing and damage
EN
EN

11.1.1 Replacement of lamps

26
Emergency Light Fitting for Fluorescent Lamps
Series 6009
Observe the relevant national regulations in the country of use.
Only use fluorescent lamps with pins made of brass.
06048E00
Measures
If exceeding the permissible ambient
temperature or falling below the device
must be taken out of operation.
Replace the exchangeable enclosure
components. If the enclosure components
are non-exchangeable, the device must be
taken out of operation.
If the device is not used according to its
intended use, it must be taken out of
operation.
clamp loose conductors tightly.
replace damaged or aged cables.
replace damaged, aged and porous seals
and completely change enclosure
components with foamed seal.
• Insert both the lamp bases into the holder
guide slots until the stop is reached.
• Move lamp to its operating position by turning
it to the right or the left.
• Remove in opposite direction.
226311 / 600960300010
2014-03-12·BA00·III·en·00