Stahl 6009/5..-....- Serie Betriebsanleitung Seite 49

170
165°
• Remove the closing cap of the central lock.
• Turn the central lock using a socket wrench M8, wrench size 13, by 90° to the left as
far as it will go.
• Swivel down the lighting trough.
• Proceed in reverse order to close.
• The seal of the luminaire trough must lie correctly on the sealing edge.
• Push the closing cap onto the central lock opening (dust protection).
Note:
• Version without switch: Disconnect the luminaire from the power supply and secure it
against being switched on again.
• Version with switch: The luminaire is positively disconnected from the power supply by
actuating the central lock.
• In open end position and with lighting trough swivelled down, a restart lock-out device
prevents the central lock from being actuated.
Please do not use force!
When the lighting trough is closed, the central lock is released.
Opening and closing the reflector plate
1
226311 / 600960300010
2014-03-12·BA00·III·en·00
15448E00
90°
15451E00
2
Mounting and installation
15436E00
1 Open the reflector plate by
pressing the safety latch.
2 Swivel down the reflector plate.
• When closing, flip up the
reflector plate and snap it into
place.
15512E00
Emergency Light Fitting for Fluorescent Lamps
Series 6009
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
17