Putting into Service
10 Putting into Service
Make sure that the device is not damaged.
Make sure that the device is installed onto the panel correctly to ensure the integrity of
the gasket seal.
11 Maintenance, Overhaul and Repair
No alteration to the unit is allowed. In case the unit becomes faulty, it must be returned
to the factory.
Risk of electrostatic discharge!
The Horn moulded parts may become electro-statically charged and should not be
touched or rubbed when in operational service.
Clean the device only with a suitable damp cloth.
Cleaning
Observe the warning given on the equipment label
Clean the device only with a suitable damp cloth
12 Disposal
The national waste disposal regulations have to be observed.
6
Hazardous Area Audible Signal - 100 dB(A)
YA11
WARNING
WARNING
211361 / D8500-003
2011-12-02·BA00·III·en·00