Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Disposal
EN
• Loosen the screws (1) (cross head H2) of the battery cover.
EN
• Open the battery case.
EN
• The switch (6) disconnects the battery circuit.
• Secure the battery cover with built-in battery on the wrist using the strap (3).
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
• Remove the battery plug from the chamber.
EN
• Disconnect the battery plug (4).
• Take off the battery cover with built-in battery (5).
EN
• Put in the new battery cover with built-in battery (5).
EN
• Connect the battery plug (4).
EN
• Loosen the strap (3) from the wrist and store it in the battery case.
• Close the battery case and ensure that the conductors do not get jammed.
EN
• Tighten the screws (1) (cross head H2) firmly (2 Nm).
EN
EN
11.2 Cleaning
EN
The luminaire is marked with the warning "Clean with damp cloth only".
• Clean the device only with a damp cloth.
• Use water or mild cleaning agents.
• Do not use abrasive, scratching and aggressive detergents or solvents.
11.3 Returning the device
Use the "Service form" to return the device when repair/service is required. On the
internet site "www.stahl-ex.com" under "Downloads > Customer service":
• Download the service form and fill it out.
• Send the device along with the service form in the original packaging to R. STAHL
Schaltgeräte GmbH.
12
Disposal
• Observe national and local regulations and statutory regulation regarding disposal.
• Separate materials when sending it for recycling.
• Ensure environmentally friendly disposal of all components according to the statutory
28
Emergency Light Fitting for Fluorescent Lamps
Series 6009
NOTE
16406E00
226311 / 600960300010
2014-03-12·BA00·III·en·00
Werbung
Kapitel
Inhaltsverzeichnis
Fehlerbehebung
