Electrical Connections - Stahl 6009/5..-....- Serie Betriebsanleitung

Mounting and installation
EN
Opening and closing the battery enclosure
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
Opening
• Loosen the screws (1) (cross head H2).
EN
• Open the battery cover (2).
EN
Closing
EN
• Close the battery cover (2).
• Tighten the screws (1) (cross head H2) firmly (2 Nm).
EN
EN

8.3.2 Electrical connections

EN
Electrical connection
Observe the maximum clamping possibility of the connecting terminals
EN
(see chapter "Technical data").
EN
For optional screw-type terminals, two conductors per clamping unit can be clamped
EN
(ingoing and outgoing wiring).
EN
Note:
• Clamping must be carried out precisely!
• Do not clamp any part of the conductor insulation!
• Do not interchange the conductors!
• Observe the technical regulations when connecting the conductor!
• Clamp the conductor firmly.
• Optional screw-type terminals: Firmly tighten screws
(tightening torque 2 Nm, for unused clamping units 0.7 Nm)!
• The terminal cover of optional screw-type terminals does not have to be removed to
clamp the conductor!
• The phase L1 must be directly connected to the grid which functions as charging
phase for the battery!
Danger due to wrong connection.
Malfunction
• Phases L and L1 must be connected in phase.
18
Emergency Light Fitting for Fluorescent Lamps
Series 6009
2
1
16404E00
NOTICE
1
2
16405E00
226311 / 600960300010
2014-03-12·BA00·III·en·00