Troubleshooting; Maintenance And Repair - Stahl 6009/5..-....- Serie Betriebsanleitung

10.3 Troubleshooting

Cause
The lamp was incorrectly inserted.
The lamp is defective.
The ballast is defective.
The switch is defective.
The lamp reached its end of service life.
LED display red
The battery is defective.
The switch in the battery case is defective. Replace the switch.
The switch in the light fitting is defective.
LED display blinking red
The battery capacity is too low.
Resetting the capacity error (blinking red).
• Replace the battery.
Automatic:
• A continuous operation test is carried out automatically after 36 hours.
• The error will be reset once the test has been passed successfully.
Manual:
• Actuate the switch in the battery case for 5 seconds.
• Release the switch.
• Actuate the switch twice within 10 seconds for a duration of 2 seconds.
• Close the battery case.
• Resetting of the capacity error will be indicated on the LED display for
• The error is reset.
Further error indications will be reset directly after troubleshooting.
If the error cannot be eliminated using the mentioned procedures:
• Contact the local representative of R. STAHL Schaltgeräte GmbH.
For fast processing, have the following information ready:
• Type and serial number
• Purchase information
• Error description
• Intended use (in particular input / output wiring)
11

Maintenance and repair

Unauthorized work being performed on the device!
Risk of injuries and material damage!
• Work performed on the device must only be carried out by appropriately
226311 / 600960300010
2014-03-12·BA00·III·en·00
5 seconds by blinking red/green.
authorized and trained personnel.
Maintenance and repair
Measure
Insert the lamp correctly.
Replace the lamp.
Replace the ballast.
Replace the switch.
Replace the lamp.
Replace the battery.
Replace the switch.
Replace the battery.
WARNING
Emergency Light Fitting for Fluorescent Lamps
Series 6009
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
25