Startup / Operation - BOMANN GS 184 NoFrost Bedienungsanleitung

Dismount the foot bracket
and the lower door hinge.
• Attach the door hinge at the other appliance side,
after you have unscrewed the
hinge pin and used it from the
other hinge side. Transfer and fix the foot bracket
too. Turn in the feet accordingly.
• Replace the appliance upright. Put the appliance
door on the hinge pin and fix it in its intended po-
sition.
• Transfer the upper door hinge at the opposite
side, after you have unscrewed the hinge pin and
used it from the other hinge side.
Put the hinge pin in the hole of
the appliance door and fasten the hinge.
• Replace the appliance cover, which you have
removed at the beginning. Tight the screws and
clip the screw covers on.
• Check if the door is aligned vertically and horizon-
tally optimally so that the smooth opening and
closing of the door is guaranteed.
• Dismount the door handle and attach it to the
corresponding other door outer side. Refer to the
instructions in "Assembling the door handle".
Transfer the cover caps on the exposed holes to
the respective other door outer side.

Startup / Operation

Startup / Operation Startup / Operation Startup / Operation
Prior to first use Prior to first use Prior to first use Prior to first use
CAUTION: CAUTION: CAUTION: CAUTION:
After transport, the appliance should be left standing
upright for about 4 hours before connecting to the
power supply. Nonobservance could lead to malfunc-
tion of the cooling system and causes an appliance
breakdown.
Clean the appliance interior including all accessory
parts. Consider the instructions which we provide in
the chapter "Cleaning".
Control panel overview Control panel ove rview
Control panel ove Control panel ove rview rview
Temperature control Temperature control Temperature control Temperature control
Setting Setting COLD COLD Setting MID Setting
Setting Setting COLD COLD Setting Setting
Lowest setting Medium setting
(warmest inside (optimal operat-
temperature) ing temperature)
Function button Function button Function button Function button
to switch off the audible warning signal
SUPER - to switch on and off the super freeze
FREEZE function
Control lamps Control lamps Control lamps Control lamps
ALARM warning lamp when temperature rises
POWER indicates the power supply
SUPER indicates the activation of the super
freeze function
Starting the appliance Starting the appliance Starting the appliance Starting the appliance
• Connect the appliance to the power supply.
• Operate the temperature control. See also the
following section "Settings".
Settings Settings Settings Settings
The power levels [COLD - COLDER] regulates the
different values of the internal temperature. Turning
the temperature control clockwise will lower the in-
side temperature.
During initial operation, turn the lowest possible tem-
perature level first or activate the super freeze func-
tion, until the appliance has reached the desired op-
erating temperature. Afterwards it is recommended to
turn the temperature back to a medium setting; cor-
recting the temperature at a later point would then be
easier.
19
MID Setting COLDER Setting COLDER
MID MID Setting Setting COLDER COLDER
Highest setting
(coldest inside tem-
perature)