Fitting The Hinged Door - AEG F75500VI Benutzerinformation

Fitting the hinged door

1. Fit the two lateral bars (A) as shown in
the figure. Align bars at the top so that
the upper hole lies over the pre-moun-
ted aligning disk. With a width of 568
mm, first fix the additionally supplied
aligning disks (B) on the already pre-
mounted aligning disks.
2. Screw in the bars at the top.
3. Put the appliance in front of the kitchen
unit into which it is to be installed. Place
cable and hoses into the neighbouring
unit. As you push the appliance in, keep
on pulling the cable and hoses through
and ensure that they are not squashed
4. Align the appliance laterally in the plinth
area with the angle (AN), tighten the
screw (V) slightly.
5. Before the installation of the hinge sup-
port: screw bottom unit of the hinge in-
to the holes provided in the hinge sup-
port.
27
Installation