Installing The Unit (In-Dash Mounting) - Kenwood DPX-7000DAB Bedienungsanleitung

INSTALLATION / CONNECTION
Part list for installation
(A) Mounting sleeve
(B) Trim plate
(C) Wiring harness
(D) Extraction key

Installing the unit (in-dash mounting)

Do the required wiring.
( 31)
Dashboard of your car
When installing without the mounting sleeve
1
Remove the mounting sleeve and trim plate
from the unit.
2
Align the holes in the unit (on both sides) with
the vehicle mounting bracket and secure the
unit with screws (commercially available).
Use only the specified screws. Using wrong screws might
damage the unit.
Bend the appropriate tabs to hold the
mounting sleeve firmly in place.
How to remove the unit
1
Fit the catch pin on the extraction keys into
the holes on both sides of the trim plate, then
pull it out.
2
Insert the extraction keys deeply into the slots
on each side, then follow the arrows as shown
below.
29
ENGLISH