Installing The Unit (In-Dash Mounting); Removing The Unit - Kenwood DPX-M3300BT Bedienungsanleitung

Installation/Connection

Installing the unit (in-dash mounting)

Do the required wiring.
(Page 26)
Dashboard of your car
Installing the unit (without mounting sleeve)
1
Remove the mounting sleeve and trim plate from the unit before
installing.
2
Align the holes in the unit (on both sides) with the vehicle mounting
bracket and secure the unit with screws (commercially available).
Use only the specified screws. Using wrong screws might damage the
unit.
Bend the appropriate tabs to hold the
mounting sleeve firmly in place.

Removing the unit

1 Fit the catch pin on the extraction keys into the holes on both sides of
the trim plate, then pull it out.
2 Insert the extraction keys deeply into the slots on each side, then
follow the arrows as shown on the illustration.
25
ENGLISH