Kenwood DPX-7000DAB Bedienungsanleitung Seite 28

TROUBLESHOOTING
Symptom Remedy
• Search from the Bluetooth device again.
No Bluetooth device is
• Reset the unit. ( 3)
detected.
• Make sure you have entered the same PIN code to
Bluetooth pairing cannot
be made.
• Delete pairing information from both the unit and the
• Adjust the microphone unit's position. ( 13)
Echo or noise is heard during
• Check the [ECHO CANCEL] setting. ( 15)
a phone conversation.
• Reduce the distance between the unit and the
Phone sound quality is
poor.
• Move the car to a place where you can get a better
• Use voice calling method in a more quiet
Voice calling method is not
successful.
• Reduce the distance from the microphone when you
• Make sure the same voice as the registered voice tag
• Reduce the distance between the unit and the
Sound is being interrupted
or skipped during playback
• Turn off, then turn on the unit and try to connect
of a Bluetooth audio player.
• Other Bluetooth devices might be trying to connect to
• Check whether the connected Bluetooth audio player
The connected Bluetooth
audio player cannot be
controlled.
• Disconnect and connect the Bluetooth player again.
24
both the unit and Bluetooth device.
Bluetooth device, then perform pairing again. ( 13)
Bluetooth device.
signal reception.
environment.
speak the name.
is used.
Bluetooth audio player.
again.
the unit.
supports Audio/Video Remote Control Profile (AVRCP).
(Refer to the instructions of your audio player.)
Symptom Remedy
"DEVICE FULL" The number of registered devices has reached its limit.
Retry after deleting an unnecessary device. ( 17,
DEVICE DELETE)
"N/A VOICE TAG" Make sure the same voice as the registered voice tag
is used.
"NOT SUPPORT" The connected phone does not support Voice
Recognition feature or phonebook transfer.
"NO ENTRY" / There is no registered device connected/found via
"NO PAIR" Bluetooth.
"ERROR" Try the operation again. If "ERROR" appears again, check
if the device supports the function you have tried.
"NO INFO" / Bluetooth device cannot get the contact information.
"NO DATA"
"HF ERROR XX" / Reset the unit and try the operation again. If this does
"BT ERROR" not solve the problem, consult your nearest service
center.