JVC KD-X342BT Bedienungsanleitung Seite 22

AUDIO SETTINGS
SPK/PRE OUT (Not applicable when 3-way crossover is selected.)
Depending on the speaker connection method, select the appropriate
setting to get the desired output. ( Speaker output settings)
SPEAKER SIZE
Depending on the crossover type you have selected ( [X ' OVER TYPE]),
2-way crossover or 3-way crossover setting items will be shown.
( 19, Crossover settings)
X ' OVER
By default, 2-way crossover type is selected.
DTA SETTINGS
For settings, 20, Digital Time Alignment settings.
CAR SETTINGS
X ' OVER TYPE Caution: Adjust the volume before changing the [X ' OVER TYPE] to
avoid the sudden increase or decrease of the output level.
2-WAY (Displayed only when [3-WAY] is selected)
YES: Selects two way crossover type. ; NO: Cancels.
3-WAY (Displayed only when [2-WAY] is selected)
YES: Selects three way crossover type. ; NO: Cancels.
SOUND EFFECT
SPACE ENHANCE (Not applicable for TUNER source.)
SMALL/MEDIUM/LARGE: Virtually enhances the sound space. ;
OFF: Cancels.
SND RESPONSE LEVEL1/LEVEL2/LEVEL3: Virtually makes the sound more realistic. ;
OFF: Cancels.
SOUND LIFT LOW/MIDDLE/HIGH: Virtually adjust the sound position heard from the
speakers. ; OFF: Cancels.
VOL LINK EQ ON: Boosts the frequency to reduce the noise heard from outside the car
or running noise of the tyres. ; OFF: Cancels.
K2 TECHNOLOGY (Not applicable for TUNER source and AUX source.)
ON: Improve the sound quality of compressed music. ; OFF: Cancels.
18
ENGLISH
Speaker output settings
[SPK/PRE OUT]
(Applicable only if [X ' OVER TYPE] is set to [2-WAY])
Select the output setting for the speakers [SPK/PRE OUT], based on the
speaker connection method.
Connection via lineout terminals
For connections through an external amplifier. ( 27)
Setting on
[SPK/PRE OUT]
REAR/REAR Front speakers output
REAR/SUB.W (default) Front speakers output
SUB.W/SUB.W Front speakers output
Connection via speaker leads
For connections without using an external amplifier. However, with this
settings you can also enjoy the subwoofer output. ( 27)
Setting on
[SPK/PRE OUT]
REAR/REAR Rear speakers output
REAR/SUB.W Rear speakers output
SUB.W/SUB.W Subwoofer output
If [SUB.W/SUB.W] is selected:
– [120HZ] is selected in [SUBWOOFER LPF] and [THROUGH] is not available.
– [POSITION R02] is selected in [FADER] and selectable range is [POSITION
R15] to [POSITION 00].
Audio signal through lineout terminal
FRONT REAR/SW
Rear speakers output
Subwoofer output
Subwoofer output
Audio signal through rear speaker lead
L (left) R (right)
Rear speakers output
Rear speakers output
(Mute)