Installing The Appliance - Küppersbusch IKE2360-1 Benutzerinformation

30
Do a final check to make sure
that:
• All screws are tightened.
• The magnetic seal adheres to
the cabinet.
• The door opens and closes
correctly.
If the ambient temperature is
cold (i.e. in Winter), the gasket
may not fit perfectly to the
cabinet. In that case, wait for the
natural fitting of the gasket. In
case you do not want to carry
out the above mentioned
operations, contact the nearest
After Sales Service Force. The
After Sales Service specialist will
carry out the reversibility of the
doors at your cost.

Installing the appliance

CAUTION! Make sure that the
mains cable can move freely.
1. If necessary cut the adhesive sealing
strip and then apply it to the appliance
as shown in figure.
x
2. Install the appliance in the niche.
3. Push the appliance in the direction of
the arrows (1) until the upper gap cover
stops against the kitchen furniture.
4. Push the appliance in the direction of
the arrows (2) against the cupboard on
the opposite side of the hinge.
5. Adjust the appliance in the niche.
Make sure that the distance between
the appliance and the cupboard front-
edge is 44 mm.
The lower hinge cover (in the
accessories bag) makes sure that the
distance between the appliance and the
kitchen furniture is correct.
Make sure that the clearance between
the appliance and the cupboard is 4
mm.
6. Open the door. Put the lower hinge
cover in position.
x
2
1