Installing The Appliance - Küppersbusch IKE327022T Benutzerinformation

34
4. Remove the lower door.
5. Loosen the lower pin.
6. On the opposite side, install the lower
pin.
7. Install the lower door.
8. Refit the pins (B) and the spacers (C) on
the middle hinge on the opposite side.
9. Install the upper door.
10. Tighten the spacer and tighten the
upper pin.
C
B
C

Installing the appliance

1. If necessary cut the adhesive sealing
strip and then apply it to the appliance
as shown in figure.
2. Drill the hinge cover (A), as shown in
figure.
Do a final check to make sure
that:
• All screws are tightened.
• The magnetic seal adheres to
the cabinet.
• The door opens and closes
correctly.
If the ambient temperature is
cold (i.e. in Winter), the gasket
may not fit perfectly to the
cabinet. In that case, wait for the
natural fitting of the gasket. In
case you do not want to carry
out the above mentioned
operations, contact the nearest
After Sales Service Force. The
After Sales Service specialist will
carry out the reversibility of the
doors at your cost.
CAUTION! Make sure that the
mains cable can move freely.
x
x