Küppersbusch IKE2360-1 Benutzerinformation Seite 27

Problem
Water flows inside the refrig-
erator.
Water flows on the floor.
The temperature in the appli-
ance is too low/too high.
Possible cause
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed cor-
rectly.
Food products are not
wrapped properly.
Temperature is set incor-
rectly.
The water outlet is clog-
ged.
Food products prevent that
water flows into the water
collector.
The melting water outlet is
not connected to the evap-
orative tray above the com-
pressor.
The temperature regulator
is not set correctly.
The door is not closed cor-
rectly.
The food products' tem-
perature is too high.
Many food products are
stored at the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened
often.
There is no cold air circula-
tion in the appliance.
Solution
Wait some hours and then
check the temperature again.
Refer to climate class chart on
the rating plate.
Allow food products to cool to
room temperature before stor-
ing.
Refer to "Closing the door".
Wrap the food products better.
Refer to "Operation" chapter.
Clean the water outlet.
Make sure that food products
do not touch the rear plate.
Attach the melting water outlet
to the evaporative tray.
Set a higher/lower temperature.
Refer to "Closing the door".
Let the food products tempera-
ture decrease to room temper-
ature before storage.
Store less food products at the
same time.
Defrost the appliance.
Open the door only if necessa-
ry.
Make sure that there is cold air
circulation in the appliance.
27