Technical Information; Technical Data; Installation - Küppersbusch IKE2360-1 Benutzerinformation

28
If the advice does not lead to
the desired result, call the
nearest brand-mark service.
Replacing the lamp
Disconnect the plug from the mains socket.
1. Remove the screw from the lamp cover.
2. Remove the lamp cover (refer to the
illustration).
3. Replace the used lamp with a new lamp
of the same power and specifically

TECHNICAL INFORMATION

Technical data

Dimensions of the recess
Height
Width
Depth
Rising time
Voltage
Frequency
The technical information are situated in the
rating plate, on the external or internal side
of the appliance and in the energy label.

INSTALLATION

WARNING! Refer to Safety
chapters.
designed for household appliances (the
maximum power is shown on the lamp
cover).
4. Install the lamp cover.
5. Tighten the screw to the lamp cover.
6. Connect the plug to the mains socket.
7. Open the door.
Make sure that the light comes on.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective door
gaskets. Contact the After Sales
Service.
mm
mm
mm
Hours
Volts
Hz
Positioning
This appliance can be installed in a dry, well
ventilated indoor where the ambient
temperature corresponds to the climate
1225
560
550
12
230 - 240
50