Herunterladen Inhalt Inhalt Diese Seite drucken

Something Not Working - Electrolux EWF1440 Gebrauchsanweisung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Something not working?

Problems which you can resolve yourself, before calling the After Sales Service.
During machine operation it is possible that one of the following messages appears on the display:
Problem with the water supply ......"No incoming water. Check tap & hose"
Problem with water draining .........."No drain. Check drain hose/filter"
Door open ......................................"Door not closed. Please check"
Once the problem has been eliminated, press the START/PAUSE button to restart the programme. If after all
checks, the problem persists, contact your local Service Centre.
Problem
• The machine does not start up:
• The machine does not fill:
• The machine fills then empties
immediately:
• The machine does not empty
and/or does not spin:
• There is water on the floor:
• Unsatisfactory washing results:
Possible cause
• The door is not firmly closed. (Door not closed.
Please check)
• The machine is not plugged in or there is no power
at the socket.
• The main fuse has blown.
• The programme selector dial is not positioned correctly
and the START/PAUSE button has not been
depressed.
• The Delay Start has been selected.
• The water tap is closed. (No incoming water.
Check tap & hose)
• The inlet hose is squashed or kinked. (No
incoming water. Check tap & hose)
• The filter in the inlet hose is blocked. (No
incoming water. Check tap & hose)
• The door is not properly closed. (Door not
closed. Please check)
• The end of the drain hose is too low. Refer to
relevant paragraph in "water drainage" section.
• The drain hose is squashed or kinked. (No drain.
Check drain hose/filter)
• A programme which ends with water in tub
(option
or
) has been selected.
• The option no spin "0" has been selected.
• The drain pump is clogged. (No drain. Check
drain hose/filter)
• Too much detergent or unsuitable detergent
(creates too much foam) has been used.
• Check whether there are any leaks from one of the
inlet hose fittings. It is not always easy to see this
as the water runs down the hose; check to see if it
is damp.
• The drain hose is damaged.
• The cap on the emergency emptying hose has not
been replaced after cleaning the pump.
• Too little or too much detergent has been used.
• An unsuitable detergent has been used.
• Stubborn stains have not been treated prior to
washing.
• The correct temperature was not selected.
• Excessive laundry load.
104

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis