the spanner in the opposite direction to the direction
of rotation (Caution! left-hand thread).
Fitting the trimmer guard and trimmer
head
•
Fit the correct trimmer guard (A) for use with the
trimmer head. CAUTION! Ensure that the guard
extension is fitted.
L
M
A
•
Hook the trimmer guard/combination guard onto the
fitting on the shaft and secure with the bolt (L).
•
Fit the drive disc (B) on the output shaft.
•
Turn the blade shaft until one of the holes in the drive
disc aligns with the corresponding hole in the gear
housing.
•
Insert the locking pin (C) in the hole to lock the shaft.
•
Screw on the trimmer head/plastic blades (H) in the
opposite direction to the direction of rotation.
H
H
•
To dismantle, follow the instructions in the reverse
order.
ASSEMBLY
G
E
F
D
B
C
H
B
C
M L
Fitting the transport guard
•
Insert the blade in the transport guard (A).
•
Snap the two fasteners (B) into the slots (C) to secure
the transport guard.
Adjusting the harness and brush
cutter
Adjusting the backplate height
•
Loosen the two fasteners holding the backplate.
A
•
Loosen the backplate from the frame on one side.
–
English
13