Operation; Maintenance; Transportation, Storage And Disposal - Husqvarna DT600 Bedienungsanweisung

To start the product with a cold engine
If you have a gasoline operated product, obey these
instructions to start the product with a cold engine.
1. Run the basic product warm and then shut down the
product.
2. Mount the attachment as per the assembly
instructions.
3. When adjusting the carburettor, make sure that the
dethatcher is held against the ground and that no
one else is in the vicinity.
4. Keep the moss dethatcher idling.
5. Make sure that the handle and safety features are in
good working order. Never use a product that lacks a
part or has been modified outside its specifications.
To use the attachment
1. Run the moss dethatcher at full gas (or nearly full
gas) with the wheels resting on the surface.
Introduction
Below you will find some general maintenance
instructions. If you need further information please
contact your service workshop.
To perform maintenance on the
attachment
CAUTION:
dethatcher is often done in dusty conditions.
If you have a gasoline operated product, it is
extremely important that the air filter is
inspected regularly, often daily, and oiled in
order to work satisfactorily.
Refer to the operator's manual of the power
unit for maintenance instructions.
WARNING:
gloves when you perform maintenance on
the attachment.
Transport and storage
If transporting the attachment on another vehicle always
use approved securing devices and make sure that the
attachment is securely held.
8

Operation

Maintenance

Much work on the moss
Always wear protective

Transportation, storage and disposal

Note:
It is both tiring and unnecessary to lift or
hold the moss dethatcher above the surface when
working.
2. Keep an acute working angle to the surface. With a
large working angle, the moss dethatcher tends to
move towards you and you risk losing control of the
product.
WARNING:
when the product has been in use. To avoid
burning yourself do not touch the gear
housing.
1. Make sure that the moss dethatcher does not rotate
when the power/thottle trigger is released.
2. Clean the wheels if they are not rotating freely.
Ensure the attachment is cleaned and that a complete
service is carried out before long-term storage.
The gear housing gets hot
743 - 005 - 07.04.2021