Scheppach HC06 Original Bedienungsanleitung Seite 48

When working with spray attachments and during temporary use out-
doors, the device must be connected to a residual current circuit breaker
with a trigger current of 30 mA or less.
Damaged electrical connection cable
The insulation on electrical connection cables is often damaged.
This may have the following causes:
• Passage points, where connection cables are passed through win-
dows or doors.
• Kinks where the connection cable has been improperly fastened or
routed.
• Places where the connection cables have been cut due to being driv-
en over.
• Insulation damage due to being ripped out of the wall outlet.
• Cracks due to the insulation ageing.
Such damaged electrical connection cables must not be used and
are life-threatening due to the insulation damage. Check the electrical
connection cables for damage regularly. Make sure that the connec-
tion cable does not hang on the power network during the inspection.
Electrical connection cables must comply with the applicable VDE
and DIN provisions. Only use connection cables with the marking
„H05VV-F".
The printing of the type designation on the connection cable is man-
datory.
AC motor
• The mains voltage must be 220 V~ / 50 Hz
• Extension cables up to 25 m long must have a cross-section of 1.5
mm .
²
Connections and repairs of electrical equipment may only be carried
out by an electrician.
48 | GB
www.scheppach.com