Scheppach HC06 Original Bedienungsanleitung Seite 42

5. Replacing the connection line
- If the connection line is damaged, it must be replaced by the
manufacturer or an electrician to avoid danger. There is a risk of
electric shock.
6. Inflating tyres
- Directly after inflating tyres, check the pressure with a suitable
pressure gauge, for example at your filling station.
7. Street-legal compressors in construction site operation
- Ensure that all hoses and fixtures are suitable for the maximum
permissible working pressure of the compressor.
8. Set-up location
- Only set up the compressor on a flat surface.
9. It is recommended to equip the feed hoses with a safety cable in
cases where the pressure is above 7 bar, e.g. using a wire cable.
10. Avoid over-stressing the piping system by using flexible hose
connections to prevent kinking.
ADDITIONAL SAFETY INSTRUCTIONS
Observe the corresponding operating manuals of the respective
compressed air tools / compressed air attachments! The following
general instructions must also be observed:
Safety instructions for working with compressed air and blasting
guns
• Ensure there is sufficient distance to the product, at least 2.50 m, and
keep the compressed air tools / compressed air attachments away
from the compressor during operation.
• The compressor pump and lines can become very hot during operation.
Touching these parts will burn you.
• The air which is sucked in by the compressor must be kept free of
impurities that could cause fires or explosions in the compressor pump.
• When releasing the hose coupling, hold the hose coupling piece with
your hand. This way, you can protect yourself against injury from the
rebounding hose.
42 | GB
www.scheppach.com