Parkside Performance PSSAP 20-Li C3 Bedienungs- Und Sicherheitshinweise Seite 84

˜ Trial run
NOTE
Always carry out a no-load trial run
u
before starting work and after every saw
blade replacement. Switch the product off
immediately if the saw blade is not running
smoothly, if considerable vibration occurs
or if you hear abnormal noises.
˜ Working instructions
m
CAUTION! RISK OF INJURY AND
DAMAGE TO PROPERTY!
Wear gloves when handling the saw blade.
u
In this way, you avoid injury from cuts.
Do not use any blunt or bent blades or
u
blades which are damaged in any other
way.
Before sawing the workpiece, check for
u
hidden foreign objects such as nails,
screws. These must be removed.
Always insert a suitable saw blade.
u
Secure the workpiece with the aid of
u
clamping devices on the workbench.
Apply only as much pressure as is required
u
for sawing. If there is excessive pressure,
the sawing blade may bend and break.
Switch the product off immediately if the
u
sawing blade jams.
Spread the saw cut out and pull the blade
out carefully.
Always stand to the side of the product
u
when working.
Always make sure that the workplace is
u
well ventilated.
Avoid over-stressing the product while
u
working.
Regular cuts
Verify the saw blade is not touching the
workpiece. Then, switch on the product.
Apply the base plate
Use even pressure, advancing at a steady
pace when making your cut. You can make
horizontal, diagonal, or vertical cuts.
When you are finished: First, switch off the
product. Then, pull the saw blade out of the
workpiece.
Plunge cuts
(Fig. J)
Plunge cuts are very challenging and are
associated with a higher risk of injuries. Only
use this technique if you are familiar with it.
Plunge cuts may only be carried out in soft
materials such as wood or plasterboard and
with short blades (max. length 150 mm).
There is a risk of kickback and personal injury.
Place the front edge of the base plate
the workpiece so that the saw blade does not
touch the workpiece.
Turn the product on. Let the saw blade slowly
plunge into the workpiece.
When the workpiece depth has been cut
through, continue sawing as usual.
Flush cuts
(Fig. K)
With elastic bi-metal saw blades you can
separate water pipes, for example, flush to
the wall.
Make sure that the saw blade is always
longer than the pipe diameter. There is a risk
of kickback and personal injury.
to the workpiece.
4 ] [
on
4 ] [
GB/MT 83