Operation; Control Board; Stand Alone-Mode - EuroLite LED Profile Spot 100W WW Bedienungsanleitung

OPERATION

After you connected the spot to the mains, the EUROLITE LED Profile Spot 100W WW starts running.
The LCD display lights up and you can choose the desired mode via the buttons MODE, UP and DOWN.

Control Board

The Control Board offers several features: for example, you can easily set the starting
address.
Browse through the main menu by pressing MODE. You can change the selection by pressing
UP or DOWN. The functions provided are described in the following sections.
Display
LED Profile Spot LCD display when starting
Disp Perm
LCD display backlight constantly on
ON
LCD display backlight switches itself off automatically after 10 mintues of
Disp Perm
operation. By pressing any button for 3 seconds, the LCD display backlight
OFF
switches itself back on.
DMX-CH1 is Dimmer; DMX-CH2 is Strobe
DMX-2CH
DMX***
DMX*** Setting of the DMX Startadresse from 001 - 512
White Set
Setting of the Dimmer brightness
Dim***
Col Strob
Setting of the Strobe speed
Speed**
The device has two operating modes. It can be operated in Stand Alone via LCD display with operating
buttons or alternately in DMX-controlled mode via lighting controller.

- STAND ALONE-MODE


Dimmer

Strobe

Master / Slave

Focusing

Zooming
- DMX MODE
STAND ALONE-MODE
In the Stand Alone mode, the LED Profile Spot 100W WW can be used without controller.
Disconnect the LED Profile Spot 100W WW from the controller.
Dimmer
Press the MODE button to select the Dimmer mode. When the display shows "White Set Dim***", you can
select the desired brightness via the UP or DOWN buttons.
Value:
000 – 255
Function:
0 – 100 % increasing brightness
Function
20/23 00076260.DOC, Version 1.1