Technical Data; Unpacking; Assembly / Before Commissioning - Scheppach Ge2900Atg Original Bedienungsanleitung

6. Technical data

Voltage control
Protection category
Continuous output P
nenn
max. Power P max. (S2 5 min)
Rated battery voltage U
Rated current I
nenn
Frequency F
nenn
Drive motor type
Displacement
Motor speed
Max. power (engine)
Fuel
Tank contents
Engine oil type (recommended)
Oil volume (approx.)
Consumption at 2/3 load
Weight
Performance class
Power factor cos φ
Quality class
Max. temperature.
Max. altitude (above mean sea
level)
Starter
Spark plug
Technical changes reserved!
Operating mode S1 (continuous operation)
The machine may be operated continuously with the
specified power.
Operating mode S2 (short-term operation)
The machine may only be operated at maximum power
for a brief time. Then, the machine must be brought to
a standstill for a period of time so that it is not allowed
to heat up.
AVR
IP23M
(S1) 2600 W
2900 W
2 - 230 V~
nenn
11.3 A
50 Hz
4-stroke 1
cylinder
air-cooled
212 cm
3000 min
4.15 kW
Unleaded petrol
13.7 l
10W30 / 15W40
0.6 l
1.4 l/h
38.2 kg
40
1000 m
Pull cable starter
F7RTC
www.scheppach.com
Noise
m Warning:Noise can have serious effects on your
health. If the machine noise exceeds 85 dB, please
wear suitable hearing protection.
Noise data
Sound power level L
Uncertainty K
WA
Sound pressure level L
Uncertainty K
pA

Unpacking

• Open the packaging and carefully remove the de-
vice.
3
• Remove the packaging material, as well as the
-1
packaging and transport safety devices (if present).
• Check whether the scope of delivery is complete.
• Check the device and accessory parts for trans-
port damage.
• If possible, keep the packaging until the expiry of
the warranty period.
m DANGER
The device and the packaging are not children's
toys! Do not let children play with plastic bags,
films or small parts! There is a danger of choking
G1
or suffocating!
1
B
7.

Assembly / Before commissioning

C
°
m ATTENTION!
Always make sure the device is fully assembled
before commissioning!
Your machine is not fully assembled.
Attention! Fill the oil before first use.
Before each use, check the oil level with the engine
switched off and on a level surface. Use the highest
quality four-stroke oil or an HD oil with the same level
of quality.
Check the oil level (Fig. 4+5)
Remove the oil filler cap (9) and wipe the dipstick
clean. Check the oil level by inserting the dipstick into
the filling nozzle without screwing the cap on. If the oil
level is too low, refill with the recommended oil. The oil
level must be between marks (a) and (b).
93.6 dB
WA
1.89 dB
80.3 dB
pA
3 dB
GB | 23