Scheppach 5903804901 Originalbetriebsanleitung Seite 23

4. Scope of delivery
Item Quantity Designation
1x
Drywall grinder
11 a 6 Sandpaper (various grit sizes)
13 1x Suction hose
13 a 2x Hose adapter
14 1x Split pin
A 1x Screwdriver for changing carbon
brushes
B 1x Allen key for changing
sandpaper
C 2x Spare carbon brush
1x Operating manual
5. Unpacking
m WARNING
The product and the packaging material are not
children's toys! Do not let children play with plas-
tic bags, films or small parts! There is a danger of
choking or suffocating!
• Open the packaging and carefully remove the product.
• Remove the packaging material, as well as the pack-
aging and transport safety devices (if present).
• Check whether the scope of delivery is complete.
• Check the product and accessory parts for transport
damage. In the event of complaints the carrier must
be informed immediately. Later claims will not be
recognised.
• If possible, keep the packaging until the expiry of the
warranty period.
• Familiarise yourself with the product by means of the
operating manual before using for the first time.
• With accessories as well as wearing parts and re-
placement parts use only original parts. Spare parts
can be obtained from your specialist dealer.
• When ordering please provide our article number as
well as type and year of manufacture for the product.
6. Technical data
Rated voltage
Nominal frequency
Power consumption
Nominal speed at no load n
230 - 240 ~ V
50 Hz
710 W
800 - 1800 rpm
0
www.scheppach.com
Spindle size
Sandpaper diameter
Protection class
Weight
Sound levels
Sound pressure level L
PA
Sound power level L
WA
Uncertainty K
Hand-arm vibration
when grinding with sandpaper a
Uncertainty K
Subject to technical changes!
Wear hearing protection!
Exposure to noise can cause hearing loss.
Note:
• The noise and vibration values have been deter-
mined in accordance with EN 62841-1.
Note:
The total vibration emission values specified and the
device emissions values specified have been meas-
ured in accordance with a standardised test procedure
and can be used for comparison of one electric tool
with another.
Note:
The total vibration emission values specified and the
device emissions values specified can also be used for
an initial estimation of the load.
Warning: The vibration values and noise emission
values can vary from the specified values during the
actual use of the power tool, depending on the type and
the manner in which the power tool is used, and in par-
ticular the type of workpiece being processed.
Warning: It is necessary to determine the safety
measures for the protection of the operator based on
an assessment of the vibration load during the actual
conditions of use (In doing so, all parts of the operat-
ing cycle must be taken into account such as times in
which the power tool is switched off or times in which it
is switched on, but is not running under a load).
M14
215 mm
II
3.8 kg
91.3 dB
99.3 dB
3 dB
2.28 m/s
2
h
1.5 m/s
2
GB | 23