Introduction; Proper Use; Product Description (Fig. 1-13) - Scheppach 5903804901 Originalbetriebsanleitung

1.

Introduction

Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer
We hope your new product brings you much enjoyment
and success.
Note:
In accordance with the applicable product liability laws,
the manufacturer of this product assumes no liability
for damage to the product or caused by the product
arising from:
• Improper handling
• Failure to comply with the operating manual
• Repairs carried out by third parties, unauthorised
specialists
• Installing and replacing non-original spare parts
• Improper use
• Failures of the electrical system due to failure to observe
the national electrical requirements and regulations.
Note:
The operating manual is part of the product and contain
important information for safe, proper and economical
operation. Please also observe the applicable national
regulations. Read all operating and safety instructions
carefully before use and only use the product as de-
scribed. Keep the manual and pass it on when you give
the product to someone else.

2. Proper use

The intended use of this product is the grinding of large
areas of drywalls with suitable sandpaper as a prepara-
tion before painting or wallpapering.
This product is neither suited for the preparation of
small areas, corners and edges, nor for the removal of
wallpaper and the grinding of ceilings and wet grinding.
Do not use the product for cutting or roughing or pol-
ishing. Do not use it together with wire brushes. Do not
treat asbestos containing materials with this product.
The product may only be used in the intended manner.
Any use beyond this is improper. The user/operator, not
the manufacturer, is responsible for damages or inju-
ries of any type resulting from this.
22 | GB
An element of the intended use is also the observance
of the safety instructions, as well as the assembly in-
structions and operating information in the operating
manual.
Persons who operate and maintain the product must be
familiar with the manual and must be informed about
potential dangers.
The liability of the manufacturer and resulting damages
are excluded in the event of modifications of the product.
The product may only be operated with original parts
and original accessories from the manufacturer.
The safety, operating and maintenance specifications
of the manufacturer, as well as the dimensions speci-
fied in the technical data, must be observed.
Please note that our products were not designed with
the intention of use for commercial or industrial purpos-
es. We assume no guarantee if the product is used in
commercial or industrial applications, or for equivalent
work.
The manufacturer is not liable for damage caused by
improper use or incorrect operation.

3. Product description (Fig. 1-13)

1. Suction connection
2. Additional handle
3. Suction pipe extension
4. Mains cable
5. Main handle
5a. Suction connection
6. On/off switch
6a. Speed control
6b. Locking knob
7. LED light
7a. On/off switch
8. Wing nut
9. Front handle
10. Ventilation openings
11. Grinding head
11a. Sandpaper
11b. Grinding disc
11c. Brush edge
12. Cover
12a. Bracket
13. Suction hose
13a. Hose adapter
14. Split pin
www.scheppach.com