Troubleshooting; Possible Cause - Scheppach Cs1300 Original Bedienungsanleitung
Handkreissäge
Verfügbare Sprachen
Verfügbare Sprachen
14. Troubleshooting
The following table shows fault symptoms and describes remedial measures in the event of your machine failing to work
properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
Fault
Device does not start
Motor stops during operation
Unclean cut
www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
Possible cause
No power supply
Triggered overload protection
On/off switch defective
Motor defective
Triggered overload protection
Motor defective
Screws or parts of the electric tool
are loose.
The sawblade is not properly insert-
ed.
The sawblade is worn out.
Remedy
Check the power connection and the socket.
Allow the engine to cool down.
Repair by an authorised service centre.
Repair by an authorised service centre.
Allow the engine to cool down.
Repair by an authorised service centre.
Tighten up all the screws.
Insert the sawblade correctly.
Check the sawblade. Replace worn sawblades.
GB | 27
Fehlerbehebung
