Technical Data; Unpacking - Scheppach Fs3600 Originalbetriebsanleitung

• Residual risks can be minimised if the "Safety In-
structions" and the "Intended Use" together with the
operating manual as a whole are observed.
• Avoid accidental starting of the product: the oper-
ating button may not be pressed when inserting the
plug in a socket. Use the tool that is recommended
in this operating manual. This is how to ensure that
your product provides optimum performance.
• Keep your hands away from the working area when
the machine is in operation.

2. Technical data

Engine output
Operating mode
motor speed
AC motor
Insulation material class
Protection category
Cut length
Cutting height 90°
Cutting height 45°
Cutting table
Dimensions
Working height
Diamond cutting wheel
Weight
Subject to technical changes!
* The duty cycle S2 20 min (short-time duty)
states that the motor may only be continu-
ously loaded with the rated power (1200 W) for
the time specified on the data plate (20 min).
Otherwise, it would heat up impermissibly.
During the pause, the motor cools down again to
its initial temperature.
Noise & vibration
m Warning: Noise can have serious effects on your
health. If the machine noise exceeds 85 dB, please
wear suitable hearing protection.
28 | GB
FS4700 FS3600
1200 W 900 W
S2 20 min*
3000 rpm
230 V~ 50Hz
F
IP54
1200 mm 920 mm
40 mm 36 mm
34 mm 29 mm
180 x 230 mm
400 x 400 x
1377 mm 1290 mm
780 mm
Ø 230 Ø 200
mm x Ø mm x Ø
25.4 mm 25.4 mm
57 kg 51.5 kg
www.scheppach.com
Noise data
Sound power level L
WA
Uncertainty K
wa
Sound pressure level L
pA
Uncertainty K
pA
The noise emission and vibration values determined
using this document apply only to the operating and
installation conditions specified in this document. Oth-
er operating and installation conditions (e.g. cutting
wheels, the material to be cut and the way in which the
operator uses the machine) may lead to an increase in
noise and vibration emissions.
The emission values determined in this document are
useful for comparing machines and do not represent
exposure levels.
Factors influencing the actual level of noise exposure
include the characteristics of the working environment,
other nearby noise sources during operation, and the
duration of exposure.
Factors influencing the actual level of vibration expo-
sure include the duration of exposure and the condition
of the machine.

3. Unpacking

• Open the packaging and carefully remove the prod-
uct.
• Remove the packaging material, as well as the pack-
aging and transport safety devices (if present).
• Check whether the scope of delivery is complete.
• Check the product and accessory parts for transport
damage. In the event of complaints the carrier must
be informed immediately. Later claims will not be
recognised.
• If possible, keep the packaging until the expiry of the
warranty period.
• Familiarise yourself with the product by means of the
operating manual before using for the first time.
• With accessories as well as wearing parts and re-
placement parts use only original parts. Spare parts
can be obtained from your specialist dealer.
• When ordering please provide our article number as
well as type and year of manufacture for the product.
85 dB
2.5 dB
72 dB
3 dB