Troubleshooting - Scheppach 5801202901 Originalbetriebsanleitung

14. Troubleshooting

Fault Possible cause
Motor does not work Motor, cable or plug defective, fuses
burnt
The motor starts Voltage too low, coils damaged, capac-
up slowly and does itor burnt
not reach operating
speed.
Motor makes exces- Coils damaged, motor defective
sive noise
The motor does not Circuits in the network are overloaded
reach its full power. (lamps, other motors, etc.)
Motor overheats Overloading of the motor, insufficient
easily. cooling of the motor
Reduced cutting Saw blade too small (ground too
power when sawing much)
Saw cut is rough or Saw blade dull, tooth shape not appro-
wavy priate for the material thickness
Workpiece pulls Excessive cutting pressure and/or saw
away and/or splinters blade not suitable for use
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
Remedy
Arrange for inspection of the machine by a specialist.
Never repair the motor yourself. Danger!
Check fuses and replace as necessary.
Contact an electrician to check the voltage.
Arrange for inspection of the motor by a specialist.
Arrange for replacement of the capacitor by a
specialist.
Arrange for inspection of the motor by a specialist.
Do not use any other equipment or motors on the
same circuit.
Avoid overloading the motor while cutting, remove
dust from the motor in order to ensure optimal
cooling of the motor.
Readjust end stop of the saw unit.
Resharpen saw blade and/or use suitable saw blade.
Insert suitable saw blade.
GB | 35