Mains Connection - Scheppach P-Kv51 Original Bedienungsanleitung

9.1 Fitting the wheels (fig. 6,7)
Screw on each wheel (3) one washer (C) and one nut (B) on to
•
the threads of the wheels.
Then mount the wheels (3) on the wheel holders, at the bottom
•
of the pressure vessel (2), by using a wrench to fix the nut (B),
washer (C) and flange nuts (D) on the other side of the thread.
9.2 Fitting the supporting foot (fig. 5)
Mount the enclosed supporting foot (4) with the two hex bolts
•
(A), the two washers (C) and two flange nuts (D), as shown in
Figure 5.

9.3 Mains connection

The compressor is equipped with a mains cable with shock-
•
proof plug. This can be connected to any 230V~ / 50 Hz shock-
proof socket which is protected by a 16 A fuse.
Before you use the machine, make sure that the mains voltage
•
is the same as the operating voltage (see the rating plate).
Long supply cables, extensions, cable reels etc. cause a drop
•
in voltage and can impede motor start-up.
At low temperatures below +5 °C, sluggishness may make start-
•
ing difficult or impossible.
9.4 ON/OFF switch (fig. 2)
To switch on the compressor, press the button (8) on position I.
•
To switch off the compressor, press the button (8) on position 0.
•
9.5 Setting the pressure (fig. 2)
You can adjust the pressure on the pressure gauge (6) using
•
the pressure regulator (7).
The set pressure can be taken from the quick lock coupling (5).
•
40 | GB
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58