Have your electric tool repaired by a qualified electrician
15
This electric tool conforms to the applicable safety regulations.
–
Repairs may only be performed by an electrician using original
spare parts. Otherwise accidents can occur.
Important!
16
For your own safety you must only use the accessories and
–
additional units listed in the operating instructions or recom-
mended or specified by the manufacturer. The use of mount-
ed tools or accessories other than those recommended in
the operating instructions or catalog may place your personal
safety at risk.
Noise
17
Wear ear muffs when you use the compressor.
–
Replacing the power cable
18
To prevent hazards, leave the replacement of damaged power
–
cables strictly to the manufacturer or a qualified electrician.
There is a risk of electric shock!
Inflating tires
19
Directly after inflating tires, check the pressure with a suitable
–
pressure gauge, for example at your filling station.
Roadworthy compressors for building site operations
20
Make sure that all lines and fittings are suitable for the maxi-
–
mum permissible operating pressure of the compressor.
Place of installation
21
Set up the compressor on an even surface.
–
ADDITIONAL SAFETY INSTRUCTIONS
Safety instructions for working with compressed air and
blasting guns
• The compressor pump and lines can become very hot during
operation. Touching these parts will burn you.
• The air which is sucked in by the compressor must be kept free
of impurities that could cause fires or explosions in the com-
pressor pump.
www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
GB | 35