Device Information; Device Accessories; Device Installation And Setup; Inserting The Batteries - Microlife Bpb1 Smart Bedienungsanleitung

3. Device information

Package Contents
1 x Microlife BP B1 BT
1 x Instruction manual
1 x Microlife Soft Cuff M-L
4 x 1.5 V alkaline batteries; type LR3 (AAA)
CAUTION: Inspect the device, cuff, and other parts for
damage. DO NOT USE the device, cuff or parts if they
appear damaged or operating abnormally.

Device accessories

Blood pressure cuffs
Microlife offers cuffs, covering a wide range of arm sizes.
Microlife Soft Cuff M
Microlife Soft Cuff M-L
Contact your local authorized Microlife distributor if the standard
cuff of the device is not the correct size for your arm.
AC adapter
You can operate this device using the Microlife AC adapter model
DSA-5PF21-05 (DC 5V, 1.0 A).
Warning: Do not use the AC adapter if the adapter or the
cable is damaged. If the device, adapter, or cable is
damaged, turn off the power and unplug the AC adapter
immediately.
Warning: Only use the AC adapter with outlets of
compatible voltage rating.
Warning: Do not plug or unplug the AC adapter from the
outlet with wet hands.
Warning: Do not damage the AC Adapter.
Handle the AC adapter with care. Avoid pulling, bending,
and tempering of the adapter cable.
Warning: Unplug the AC adapter before
cleaning this device.
Warning: The mains adapter is not waterproof.
DO NOT pour or spray liquid on the mains adapter.

Note: When using the AC adapter, it is recommended to
remove the batteries to prevent draining.
Microlife BP B1 Smart

1. Plug the adapter jack into a suitable adapter socket 7.
Check to ensure the adapter or cable are not damaged.
2. Plug the adapter plug into the mains socket.
Batteries
Use 4 new 1.5 V, size LR3 (AAA) alkaline batteries.
You can also operate this device using rechargeable batteries.
Range 22–32 cm

Range 22–42 cm


Flat battery – replacement
When the batteries are flat, the battery symbol AO will flash as soon
as the device is switched on (flat battery displayed). You cannot
take any further measurements and must replace the batteries.
1. Open the battery compartment 8 at the back of the device.
2. Replace the batteries – ensure correct polarity as shown by the
symbols in the compartment.
3. To set date and time, follow the procedure described in Section
«Setting the date and time».


4. Device installation and setup

Inserting the batteries

After you have unpacked your device, first insert the batteries. The
battery compartment 8 is on the bottom of the device. Insert the
Note: When the AC adapter is detected by the device, the
external power source indicator BM will be displayed on the
display.
Caution: Do not use expired batteries or mix new and used
batteries together.
Caution: Remove batteries if the device is not going to be
used for a prolonged period.
Only use «NiMH» type reusable batteries.
Batteries must be removed and recharged when the flat
battery symbol appears. They should not remain inside the
device as they may become damaged (total discharge as a
result of low use of the device, even when switched off).
Batteries cannot be charged in the blood pressure monitor.
Recharge batteries in an external charger and observe the
information regarding charging, care and durability.
The measurements stored in the memory are deleted when
the batteries are removed from the battery compartment
(e.g. when replacing batteries).
5 EN