Changing The Fuse In The Car Charger Adapter - Silvercrest SFA 40 A2 Bedienungsanleitung

Changing the fuse in the car charger adapter

There is a fuse in the car charger adapter
on-board power supply. If the device no longer works, check the fuse
and replace if necessary.
♦ Open the car charger adapter
(C) carefully anticlockwise with a pair of pliers and carefully
removing it.
♦ Remove the plug tip (B) from the fuse (A) and pull out the fuse.
♦ Now insert a new type F2AL 250 V fuse into the car charger
adapter
of the fuse and screw the previously removed screw insert (C)
back in.
DANGER
► Replace the fuse only with another of the same type. Fuses
with a different rating could cause a fire.
NOTE
► If the device still does not work or the fuse blows again im-
mediately, the device is defective. In this case, please contact
the Service Hotline (see section "Service").
■ 22 │ GB │ IE │ NI
, fit the plug tip (B) onto the slightly protruding end
to protect the vehicle's
by turning the screw insert
SFA 40 A2