Faults With Display - Kärcher B 140 R Originalbetriebsanleitung

Display
Seat switch broken seat switch open! Seat contact switch has not been
Release accelerator! release throttle? The gas pedal is depressed
Battery depleted -> battery empty ->
charge! charge!
Descargar totalmente battery totally dis-
bateria!! charged!
Dirt reservoir full, clean- sewage tank full
ing stopped cleaning stops
Operating hours set to 0! operating hours
set to 0!
Module temperature moduletemp.
high! Let it cool down! high let cool
down!
Drive motor hot! Let it drive motor hot!
cool down! let cool down!
Contactor open!! contactor open!! Defective controls.
Shut down, missing bus Shutdown, miss-
supply ing bus supply

Faults with display

Cause
activated.
when the main switch is on.
The discharge level of the battery
has been reached. Cleaning
units can no longer be operated.
Drives and lighting can be acti-
vated.
More than the permissible bat-
tery capacity has been utilised.
All units will be switched off. Ma-
chine is no longer ready for oper-
ations.
Dirt water reservoir is full.
Internal machine error while sav-
ing the number of operating
hours. During restart, the operat-
ing hours are always reset to 0.
Controls are too hot.
Drive motor has got overheated
due to a steep climb or locked
brake.
10
-
EN
Remedy
The machine operates only if the operator is seated on the
seat.
Take your foot off the accelerator before switching on the
main switch. If the fault recurs, call customer service.
Drive the machine to the charging station and charge the
battery.
Manually unlock the front wheel brake (see "Operation /
push appliance"). Move the machine slowly to the charging
station. Charge battery.
Empty the dirt water reservoir.
None, for information.
Set main switch to "0". Wait at least 10 minutes. Set main
switch to "1".
Set main switch to "0". Wait at least 10 minutes. Set main
switch to "1". If possible, use the unit only on level surfac-
es. If required, check the functioning of the immobilising
brake and driving pedal.
Set main switch to "0". Wait at least 10 minutes. Set main
switch to "1".
Inform Customer Service
27