Drill Safety Warnings; Vibration And Noise Reduction - Parkside 502308 2504 Bedienungsanleitung Und Originalbetriebsanleitung

medical help. Liquid ejected from the
battery may cause irritation or burns .
5) Do not use a battery pack
or tool that is damaged or
modified. Damaged or modified
batteries exhibit unpredictable
behaviour resulting in fire, explosion or
risk of injury .
6) Do not expose a battery pack
or tool to fire or excessive
temperature. Exposure to fire or
temperature above 130 °C may cause
explosion .
7) Follow all charging instruction and
do not charge the battery pack or
tool outside the temperature range
specified in the instruction. Charging
improperly or at temperatures outside
the specified range may damage the
battery and increase the risk of the fire.
Service
1) Have your power tool serviced by
a qualified repair person using only
identical replacement parts. This
will ensure that the safety of the power
tool is maintained .
2) Never service damaged battery
packs. Service of battery packs
should only be performed by the
manufacturer or authorized service
providers .
˜ Drill safety warnings
1. Safety instructions for all operations
1) Hold the power tool by insulated
gripping surfaces, when performing
an operation where the accessory
tool or fasteners may contact
hidden wiring. Accessory tools or
fasteners contacting a "live" wire may
make exposed metal parts of the
power tool "live" and could give the
operator an electric shock .
2. Safety instructions when using long
drill bits
1) Never operate at higher speed
than the maximum speed rating of
the drill bit. At higher speeds, the
drill bit is likely to bend if allowed to
rotate freely without contacting the
workpiece, resulting in personal injury .
2) Always start drilling at low speed
and with the drill bit tip in contact
with the workpiece. At higher
speeds, the drill bit is likely to bend
if allowed to rotate freely without
contacting the workpiece, resulting in
personal injury .
3) Apply pressure only in direct line
with the drill bit and do not apply
excessive pressure. Drill bits can
bend causing breakage or loss of
control, resulting in personal injury .
˜ Vibration and noise reduction
To reduce the impact of noise and
vibration emission, limit the time of
operation, use low-vibration and low-noise
operating modes as well as wear personal
protective equipment .
Take the following points into account to
minimise the vibration and noise exposure
risks:
Only use the product as intended by
its design and these instructions .
Ensure that the product is in good
condition and well maintained .
Use correct accessory tools for the
product and ensure they are in good
condition .
Keep tight grip on the handles/grip
surface .
Maintain this product in accordance
with these instructions and keep it well
lubricated (where appropriate) .
Plan your work schedule to spread any
high vibration tool use across a longer
period of time .
GB/IE 31