Replacing Of The Illuminant - Pkm KG162.4A+ Bedienungsanleitung

Cooling compartment
1. The cooling compartment is equipped with an automatic defrost-system.
2. The water is drained at the back inside the appliance.
3. The water is collected in a container underneath the compressor. The water
evaporates in this container
4. The drain must not be blocked.
5. Clean the drain carefully with a pipe cleaner.
Freezing compartment
1. Remove the contents from the freezing-compartment and put them into a
cooling box.
2. Place a container in front of the appliance to catch the water.
3. Switch off the appliance by turning the thermostat to position 0/AUS/OFF and
disconnect it from the mains.
4. When the encrusted ice melts put some dry cloths into the freezer-compartment
to hold the water back.
5. Remove the big pieces of ice first.
6. Afterwards remove the small pieces of ice.
7. Wipe and dry the appliance and door seals with dry and soft cloths.
8. After cleaning leave the door open for some time to ventilate the appliance.

5.2 Replacing of the illuminant

1. WARNING! Switch off and unplug the appliance. Risk of electrical
shock!
2. Remove the glass shelves by pulling them carefully off their guidance.
3. Remove the plastic cover of the bulb and screw out the bulb.
4. Install a new bulb (max. 1.5 W LED/ 220V-240V).
5. Fix the cover.
6. Replace the glass shelves
According to the EU regulation No. 244/2009, your appliance is classified as a
household appliance in accordance with the ecodesign requirements for non-
34